Easy Cleaning Steps For Aroma Diffuser Tt-Ad002

The TaoTronics TT-AD002 aroma diffuser can be cleaned by following the steps below:

- Unplug the diffuser before cleaning.

- Empty the diffuser after each use.

- Wipe out the diffuser's interior with a paper towel dampened with white vinegar or water with a dot of all-natural dish soap.

- Clean the ultrasonic plate or chip by dipping a cotton swab into rubbing alcohol and rubbing it over the plate or chip to remove excess oil build-up.

- Wipe the diffuser out again with a dry paper towel.

For a deep clean, perform the following steps at least once a month:

- Unplug the appliance and empty any standing water and essential oils.

- Fill the diffuser halfway with plain water and add 10 drops of distilled white vinegar.

- Plug the diffuser back in and run it for 10 to 15 minutes.

- Unplug the diffuser and empty the vinegar and water solution.

- Use a soft cloth to wipe down and thoroughly dry the reservoir.

- Wipe down the ultrasonic chip or plate with a cotton swab dipped in rubbing alcohol.

- Wipe down the exterior of the unplugged diffuser with a cloth dampened with plain water.

Unplug the diffuser and empty any water

Unplugging the diffuser and emptying any water is the first step in cleaning your TaoTronics aroma diffuser model TT-AD002. This is a safety precaution to prevent any accidental damage to the appliance. The user manual for the TT-AD002 diffuser recommends unplugging the power cord and removing the cover before draining any remaining water from the tank.

The manual also suggests cleaning the water tank with a brush when grime builds up. This can be done by removing the tank cover and adding water until it reaches the maximum water level line. A few drops of essential oil can then be drizzled into the tube until dispensing starts. The tank cover should then be put back on.

For a more thorough clean, the manual recommends unplugging the unit and emptying the tank through the water outlet. This can be done by adding 3-5 grams of baking soda and filling the tank halfway with warm water. The solution should be stirred until the baking soda is fully dissolved. The tank and cover can then be wiped down with a small brush or soft cloth dipped in the baking soda solution. The solution should be drained, and the tank rinsed under running water. Finally, the inside and outside of the diffuser should be dried with a towel or clean cloth.

Clean the reservoir with vinegar or mild detergent

To clean the reservoir of your TaoTronics Aroma Diffuser (Model: TT-AD002) using vinegar or mild detergent, follow these steps:

• Unplug the power cord and remove the cover.
• Drain any remaining water from the tank.
• If using vinegar, mix one part vinegar with two parts water in a separate container. If using mild detergent, add a small amount to warm water.
• Fill the tank halfway with the vinegar or detergent solution. Stir it to fully dissolve.
• Soak the reservoir for about half an hour.
• Thoroughly clean the grime at the bottom and atomizer (slot at the centre) of the tank with a small brush.
• Rinse the reservoir with clean water to remove any remaining solution.
• Wipe the inside and outside of the reservoir dry with a clean, dry cloth or towel.

It is recommended to clean your diffuser once a month or when the mist output is low due to grime build-up.

Clean the ultrasonic plate with a cotton swab and rubbing alcohol

To clean the ultrasonic plate with a cotton swab and rubbing alcohol, follow these steps:

• Dip a cotton swab into rubbing alcohol.
• Gently rub the swab over the ultrasonic plate or chip to remove excess oil build-up.
• The ultrasonic plate or chip breaks down the oils so that the water can disperse the molecules into the air.

Dry the diffuser and reassemble

After cleaning the diffuser, dry the inside and outside with a dry towel or clean cloth. Then, reassemble the diffuser and plug it in to refill and use.

Deep clean once a month

To deep clean your TaoTronics Aroma Diffuser (model: TT-AD002) once a month, follow these steps:

• Unplug the diffuser and empty any standing water and essential oils. Never submerge any part of the diffuser in water or get excess moisture into any control buttons.
• Fill the diffuser halfway with plain water. Add 10 drops of distilled white vinegar to help clean and disinfect the reservoir tank. Do not use any other type of vinegar or cleaner in the tank.
• Plug the diffuser back in and run it for 10 to 15 minutes to let the vinegar and water cut through built-up oils in the tank.
• Unplug the diffuser and empty the vinegar and water solution. Use a soft cloth to wipe down and thoroughly dry the reservoir.
• Wipe down the ultrasonic chip or plate with a cotton swab dipped in rubbing alcohol.
• Wipe down the exterior of the unplugged diffuser with a cloth dampened with plain water. Reassemble the diffuser and plug it in to refill and use.

Frequently asked questions